Dlp- D355 Change Distance Extension Port Settings For The Fc_Mr-4 Card - Cisco ONS 15454 SDH Procedure Manual

Chapter 20 DLPs D300 to D399
Table 20-27
Parameter
Link Recovery Enables or disables link recovery if a local
Media Type
Click Apply.
Step 4
Return to your originating procedure (NTP).
Step 5
DLP-D355 Change Distance Extension Port Settings for the FC_MR-4 Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
For the default values and domains of user-provisionable card settings, refer to the "Network Element
Note
Defaults" appendix in the Cisco ONS 15454 SDH Reference Manual.
In node view, double-click the FC_MR-4 card where you want to change the port settings.
Step 1
Click the Provisioning > Port > Distance Extension tabs.
Step 2
Modify any of the settings described in
Step 3
fields you can choose an option from a drop-down list; in others you can type a value or select or deselect
a check box.
78-17194-01

DLP- D355 Change Distance Extension Port Settings for the FC_MR-4 Card

FC_MR-4 Card General Port Settings (continued)
Description
port is inoperable. If enabled, a link reset
occurs when there is a loss of transport from
a cross-connect switch, protection switch,
or an upgrade.
Sets the proper payload value for the
Transparent Generic Framing Protocol
(GFP-T) frames.
This task changes the distance extension parameters for FC_MR-4 ports.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
Table 20-28
Options
—
Fibre Channel - 1 Gbps
•
• Fibre Channel - 2 Gbps
• FICON 1 Gbps
• FICON 2 Gbps
Unknown
•
by clicking in the field you want to modify. In some
Cisco ONS 15454 SDH Procedure Guide, R7.0
20-61