Dlp- D114 View Conditions - Cisco ONS 15454 SDH Procedure Manual

DLP- D114 View Conditions

Note
Step 3 Return to your originating procedure (NTP).
DLP-D114 View Conditions
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 From card, node, or network view, click the Conditions tab.
Click Retrieve
Step 2
The Retrieve button requests the current set of fault conditions from the node, card, or network. The
window is not updated when events change on the node. You must click Retrieve to see any changes.
Cisco ONS 15454 SDH Procedure Guide, R7.0
18-16
Alarms that have been raised during the session will have a check mark in the Alarms window
New column. When you click Synchronize, the check mark disappears.
Use this task to view conditions [events with a Not Reported (NR) severity]
at the card, node, or network level. The Conditions tab gives you a clear
record of changes or events that do not result in alarms.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Retrieve or higher
(Figure 18-5).
Chapter 18 DLPs D100 to D199
78-17194-01