Dlp- D210 Change Aic-I Card Orderwire Settings - Cisco ONS 15454 SDH Procedure Manual

Chapter 19 DLPs D200 to D299
DLP-D210 Change AIC-I Card Orderwire Settings
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
When provisioning orderwire for ONS 15454 SDHs residing in a ring, do not provision a complete
Caution
orderwire loop. For example, a four-node ring typically has east and west ports provisioned at all four
nodes. However, to prevent orderwire loops, provision two orderwire ports (east and west) at all but one
of the ring nodes.
Before you begin, make a list of the ONS 15454 SDH slots and ports that require orderwire
Tip
communication.
In node view, double-click the AIC-I card to display it in card view.
Step 1
Click the Provisioning > Local Orderwire tabs or the Provisioning > Express Orderwire tabs,
Step 2
depending on the orderwire path that you want to create.
If needed, adjust the transmit (Tx) and receive (Rx) decibel referred to one milliwatt (dBm) by moving
Step 3
the slider to the right or left for the headset type (four-wire or two-wire) that you will use. In general,
you should not need to adjust the dBm.
If you want to turn on the audible alert (buzzer) for the orderwire, check the Buzzer On check box.
Step 4
Click Apply.
Step 5
Return to your originating procedure (NTP).
Step 6
78-17194-01
This task changes the orderwire settings on the AIC-I card.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher

DLP- D210 Change AIC-I Card Orderwire Settings

Cisco ONS 15454 SDH Procedure Guide, R7.0
19-7