Required/As Needed As Needed; Onsite/Remote Onsite Or Remote; Security Level; Step 1 - Cisco ONS 15454 SDH Procedure Manual

NTP- D170 Create Protection Groups
Complete the

Step 1

to set up timing. If you are already logged in, continue with Step 2.
Complete the
Step 2
integrated timing supply (BITS) source is available. This is the common SDH timing setup procedure.
Complete the
Step 3
external BITS source is not available). This task can only provide SETS timing.
Note
Stop. You have completed this procedure.
NTP-D170 Create Protection Groups

Purpose

Tools/Equipment

Prerequisite Procedures

Required/As Needed

Onsite/Remote

Security Level

Complete the
Step 1
protection group. If you are already logged in, continue with Step 2.
Table 4-1
Cisco ONS 15454 SDH Procedure Guide, R7.0
4-10
"DLP-D60 Log into CTC" task on page 17-49
"DLP-D69 Set Up External or Line Timing" task on page 17-58
"DLP-D70 Set Up Internal Timing" task on page 17-61
For information about SDH timing, refer to the "Timing" chapter in the Cisco ONS 15454 SDH
Reference Manual or ITU-T G.784.
This procedure creates ONS 15454 SDH card protection groups.
None
NTP-D24 Verify Card Installation, page 4-2
As needed
Onsite or remote
Provisioning or higher
"DLP-D60 Log into CTC" task on page 17-49
describes the protection types available on the ONS 15454 SDH.
Chapter 4
the ONS 15454 SDH node where you want
if an external building
if you cannot complete
at the node where you want to create the
Turn Up a Node
Step 2 (an
78-17194-01