Ntp- D332 Bridge And Roll Traffic - Cisco ONS 15454 SDH Procedure Manual

Chapter 7 Manage Circuits
NTP-D332 Bridge and Roll Traffic
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note Using the bridge and roll feature, you can upgrade an unprotected circuit to a fully protected circuit or
downgrade a fully protected circuit to an unprotected circuit.
Performing bridge and roll on an STM64C might cause a traffic hit of 50 ms.
Caution
Complete the
Step 1
If you are already logged in, continue with
As needed, complete the
Step 2
page
As needed, complete the
Step 3
Optical Circuit" task on page
As needed, complete the
Step 4
Routing" task on page 19-35
Manual Routing" task on page
Step 5 As needed, complete the
Optical Circuit" task on page
As needed, complete the
Step 6
78-17194-01
This procedure reroutes live traffic without interrupting service. You can
use the Bridge and Roll wizard for maintenance functions such as card
replacement or load balancing. A circuit consists of a source facility, one
or more destination facilities, and intermediate facilities (path).
None
•
•
•
•
As needed
Onsite or remote
Provisioning or higher
"DLP-D60 Log into CTC" task on page 17-49
"DLP-D234 Roll the Source or Destination of One Optical Circuit" task on
19-30.
"DLP-D235 Roll One Cross-Connect from an Optical Circuit to a Second
19-33.
"DLP-D236 Roll Two Cross-Connects on One Optical Circuit Using Automatic
or the
19-39.
"DLP-D238 Roll Two Cross-Connects from One Optical Circuit to a Second
19-41.
"DLP-D240 Cancel a Roll" task on page
Circuits must exist on the network. See
and Low-Order Tunnels" for circuit creation procedures.
To route circuits on protected ports, you must create a protection group
using the "DLP-D73 Create a 1+1 Protection Group" task on
page 17-64 or the "NTP-D41 Create the MS-SPRing" procedure on
page 5-13.
When a roll involves two circuits, a data communications channel
(DCC) connection must exist. See the
Regenerator-Section DCC Terminations" task on page
Use the "NTP-D199 Locate and View Circuits" procedure on page 7-2
to verify that the planned Roll To paths are in service. Verify that the
planned Roll To and Roll From paths are not in the Roll Pending status,
used in test access, or used in a loopback. Refer to the
Cisco ONS 15454 SDH Troubleshooting Guide to clear any alarms.
Step 2.
"DLP-D237 Roll Two Cross-Connects on One Optical Circuit Using
Cisco ONS 15454 SDH Procedure Guide, R7.0

NTP- D332 Bridge and Roll Traffic

Chapter 6, "Create Circuits
"DLP-D363 Provision
at the ONS 15454 SDH circuit source node.
19-43.
20-68.
7-9