Cisco ONS 15454 SDH Procedure Manual page 100

NTP- D348 Install the Filler Cards
Complete the
Step 6
the FC_MR-4 card.
Note
Step 7 Continue with the
Stop. You have completed this procedure.
NTP-D348 Install the Filler Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Warning Filler cards serve three important functions: they prevent exposure to hazardous voltages and
currents inside the chassis; they contain EMI that might disrupt other equipment; and they direct the
flow of cooling air through the chassis. Do not operate the system unless all cards and faceplates are
in place. Statement 156
Always use the supplied ESD wristband when working with a powered ONS 15454_SDH. Plug the
Caution
wristband cable into the ESD jack located on the lower right outside edge of the shelf assembly and
ensure the shelf assembly is properly grounded.
Open the card ejectors.
Step 1
Cisco ONS 15454 SDH Procedure Guide, R7.0
2-14
If you insert a card into a slot provisioned for a different card, all LEDs turn off.
Note
"DLP-D335 Install GBIC or SFP/XFP Devices" task on page 20-28
If you need to remove a GBIC or SFP/XFP, complete the
SFP/XFP Device" task on page
"NTP-D19 Install Fiber-Optic Cables on Optical Cards" procedure on page
This procedure explains how to install the filler cards in any unused traffic
or AIC-I card slots (Slots 1 through 6, 9, and 12 through 17). A filler card
consists of a card with a faceplate attached. There is no label on the
faceplate and the filler card is not detectable by CTC.
Filler cards aid in maintaining proper air flow and electromagnetic
interference (EMI) requirements.
Filler cards (Cisco P/N 15454E-BLANK)
NTP-D15 Install the Common Control Cards, page 2-2
NTP-D16 Install STM-N Cards and Connectors, page 2-7
NTP-D17 Install the Electrical Cards, page 2-10
NTP-D18 Install Ethernet Cards and Connectors, page 2-11
NTP-D286 Install the FC_MR-4 Cards, page 2-12
As needed
Onsite
None
Chapter 2
"DLP-D336 Remove GBIC or
20-32.
Install Cards and Fiber-Optic Cable
to install GBICs on
2-16.
78-17194-01