Ntp- D112 Clean Fiber Connectors - Cisco ONS 15454 SDH Procedure Manual

Chapter 15 Maintain the Node
NTP-D112 Clean Fiber Connectors
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into
Warning
beams or view directly with optical instruments. Statement 1051
Using an inspection microscope, inspect each fiber connector for dirt, cracks, or scratches.
Step 1
Replace any damaged fiber connectors.
Step 2
Note
Complete the
Step 3
Complete the
Step 4
To clean multi-fiber optic connectors, complete the
Note
Connectors" task on page 19-3
Do not reuse the optical swabs. Keep unused swabs off of work surfaces.
Caution
Stop. You have completed this procedure.
78-17194-01
This procedure cleans the fiber connectors.
Inspection microscope
"Type A" Fiber Optic Connector Cleaner (CLETOP reel)
Optical swab
Optical receiver cleaning stick
None
Required
Onsite
None
Replace all dust caps whenever the equipment is unused for 30 minutes or more.
"DLP-D205 Clean Fiber Connectors with CLETOP" task on page 19-4
"DLP-D206 Clean the Fiber Adapters" task on page 19-4
as necessary.

NTP- D112 Clean Fiber Connectors

as necessary.
"DLP-D204 Clean Multi Fiber-Optic Cable
Cisco ONS 15454 SDH Procedure Guide, R7.0
as necessary.
15-15