Dlp- D41 Delete A Provisionable Patchcord - Cisco ONS 15454 SDH Procedure Manual

Chapter 17 DLPs D1 to D99
DLP-D41 Delete a Provisionable Patchcord
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Deleting the last DCC termination on an optical port automatically deletes all provisionable patchcords
Note
provisioned on the port. If the port is in a 1+1 protection group, CTC automatically deletes the patchcord
link on the protection port.
In node view, click the Provisioning > Comm Channels > Provisionable Patchcords tabs. If you are
Step 1
in network view, click the Provisioning > Provisionable Patchcords tabs.
Click the provisionable patchcord that you want to delete.
Step 2
Click Delete.
Step 3
In the confirmation dialog box, click Yes.
Step 4
Return to your originating procedure (NTP).
Step 5
DLP-D42 Install Fiber-Optic Cables on an LGX Interface
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Align the keyed ridge of the cable connector with the receiving SC connector on the LGX faceplate
Step 1
connection point. Each card supports at least one transmit and one receive connector to create an optical
carrier port.
Note
78-17194-01
This task deletes a provisionable patchcord.
None
DLP-D60 Log into CTC, page 17-49
DLP-D40 Create a Provisionable Patchcord, page 17-31
As needed
Onsite or remote
Provisioning and higher
This task installs fiber-optic cables on the Lightguide Cross Connect (LGX)
interface in the Central Office.
Fiber-optic cables
NTP-D112 Clean Fiber Connectors, page 15-15
As needed
Onsite
None
The OC12 IR/STM4 SH 1310-4 and the OC3 IR 4/STM1 SH 1310 (multiport) card faceplates
have four ports.

DLP- D41 Delete a Provisionable Patchcord

Cisco ONS 15454 SDH Procedure Guide, R7.0
17-33