Cisco ONS 15454 SDH Procedure Manual page 56

The information in the book follows a task-oriented hierarchy using the elements described in the
following sections.
Chapter (Director Level)
The guide is divided into logical work groups (chapters) that serve as director entry into the procedures.
For example, if you are arriving on site after a contractor has installed the shelf hardware, proceed to
Chapter 2, "Install Cards and Fiber-Optic Cable"
You may proceed sequentially (recommended), or locate the work you want to perform from the list of
procedures on the first page of every chapter (or turn to the front matter or index). describes the guide
chapters.
Table 1
Title
Chapter 1, "Install the Shelf and
FMECs"
Chapter 2, "Install Cards and
Fiber-Optic Cable"
Chapter 3, "Connect the PC and Log
into the GUI"
Chapter 4, "Turn Up a Node"
Chapter 5, "Turn Up a Network"
Chapter 6, "Create Circuits and
Low-Order Tunnels"
Cisco ONS 15454 SDH Procedure Guide, R7.0
xvi
Cisco ONS 15454 SDH Procedure Guide Chapters
Summary
Includes procedures for installing the shelf assembly, front
mount electrical connections (FMECs), fan-tray assembly,
LAN alarm and timing connections, electrical card cables, and
optional dense wavelength division multiplexing (DWDM)
equipment. Also included is the shelf installation acceptance
test.
Includes procedures to install common control cards, optical
cards, transponder and muxponder cards, electrical cards,
Ethernet cards and connectors, the FC_MR-4 card, and DWDM
cards. Also included are procedures for removing and replacing
a card, preprovisioning a slot, and installing and routing
fiber-optic cables.
Includes procedures to install the Cisco Transport Controller
(CTC), set up a computer for different connection types, and
log into the Cisco ONS 15454 SDH.
Includes procedures to verify the card installation; create users
and assign security; set up name, date, time and contact
information; set up network access, firewall access, and timing;
create protection groups; and provision Simple Network
Management Protocol (SNMP).
Includes procedures to verify the node turn-up and to provision
and test the following networks: point-to-point, linear add/drop
multiplexing (ADM), multiplex section-shared protection ring
(MS-SPRing), and subnetwork connection protection (SNCP).
It also includes procedures for subtending rings.
Includes procedures to verify network turn-up; create manually
or automatically routed circuits or tunnels; create
unidirectional circuits with multiple drops; create half circuits,
Ethernet circuits, and overhead circuits; provision a DWDM
optical channel network connection (OCHNC); and create
virtual concatenated (VCAT) circuits.
and begin verifying installation and installing cards.
About this Guide
78-17194-01