Cisco ONS 15454 SDH Procedure Manual page 763

Chapter 20 DLPs D300 to D399
Table 20-32
Status
PENDING_MERGE
DROP_PENDING
• Source—The circuit source in the format: node/slot/port "port name" virtual_container/tributary_
unit_group/tributary_unit_group/virtual_container. (The port name appears in quotes.) Node and
slot always appear; port "port name"/virtual_container/tributary_unit_group/tributary_unit
group/virtual_container might appear, depending on the source card, circuit type, and whether a
name is assigned to the port. For the STM64-XFP and MRC-12 cards, the port appears as port
pluggable module (PPM)-port. If the circuit is a concatenated size (VC4-2c, VC4-4c, VC4-8c, etc.)
VCs used in the circuit are indicated by an ellipsis, for example, "VC4-7.9" (VCs 7, 8, and 9) or
VC4-10..12 (VC 10, 11, and 12).
Destination—The circuit destination in same format (node/slot/port "port name"
•
virtual_container/tributary_unit_group/tributary_unit_group/virtual_container) as the circuit
source.
# of VLANS—The number of VLANs used by an Ethernet circuit with end points on E-Series
•
Ethernet cards in single card or multicard mode.
# of Spans—The number of internode links that compose the circuit. Right-clicking the column
•
shows a shortcut menu from which you can choose Span Details to show or hide circuit span detail.
State—The circuit service state, which is an aggregate of its cross-connects. The service states are
•
Unlocked, Locked, or Locked-partial. For more information about circuit service states, refer to the
"Administrative and Service States" appendix of the Cisco ONS 15454 SDH Reference Manual.
–
–
–
Step 3 Return to your originating procedure (NTP).
78-17194-01
Cisco ONS 15454 SDH Circuit Status (continued)
Unlocked—All cross-connects are in service and operational.
Locked—All cross-connects are Locked-enabled,maintenance or Locked-enabled,disabled.
Locked-partial—At least one cross-connect is Unlocked-enabled and others are in the
Locked-enabled,maintenance and/or Locked-enabled,disabled service states.
Definition/Activity
Any new circuits created to represent an alternate path in a
topology upgrade are set to this status to indicate that it is a
temporary circuit. These circuits can be deleted if a topology
upgrade fails.For more information about topology upgrades, see
the "SDH Topologies and Upgrades" chapter in the
Cisco ONS 15454 SDH Reference Manual.
A circuit is set to this status when a new circuit drop is being
added.
Cisco ONS 15454 SDH Procedure Guide, R7.0
DLP- D370 View Circuit Information
20-79