Install The Front Cover - Cisco NCS 540 Installation Manual

Connect Cables to SFP Modules
Note To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety, connect
the Gigabit Ethernet ports only to intra-building or unexposed wiring or cable. The intrabuilding cable must
be shielded and the shield must be grounded at both ends. The intra-building port(s) of the equipment or
subassembly must not be metallically connected to interfaces that connect to the OSP or its wiring. These
interfaces are designed for use as intra-building interfaces only (Type 2 or Type 4 ports as described in
GR-1089-CORE) and require isolation from the exposed OSP cabling. The addition of Primary Protectors is
not sufficient protection in order to connect these interfaces metallically to OSP wiring.
1. Connect one end of the cable to the Gigabit Ethernet port on the router.
2. Connect the other end to the BTS patch or demarcation panel at your site.
Connect Cables to SFP Modules
For information on connecting cables to Cisco optical and Ethernet SFP interfaces, see:
http://www.cisco.com/en/US/partner/products/hw/modules/ps5455/prod_installation_guides_list.html.

Install the Front Cover

The front cover protects the system from dust. Ensure the disturbance to cable routing is minimal to avoid
loss of connection.
1. Place the cable sleeve close to the router.
2. Secure the fiber or cable bundle in the cable sleeve.
3. Slide the front cover with cable sleeve and secure it with the fasteners on the cable cover.
Figure 21: Install the Front Cover Assembly
Cisco Network Convergence System 540 Passive Cooled Small Density Routers Hardware Installation Guide
44
Install the Cisco N540-6Z14S-SYS-D Routers