Complete The "Dlp-D60 Log Into Ctc" Task; Step 2; Ntp- D34 Set Up Snmp - Cisco ONS 15454 SDH Procedure Manual

NTP- D34 Set Up SNMP

Table 4-1
Type
Splitter
Unprotected
Complete one or more of the following tasks depending on the protection groups you want to create:

Step 2

•
•
•
Note
Note
Stop. You have completed this procedure.
NTP-D34 Set Up SNMP
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
If you are already logged in, continue with Step 2.
In node view, click the Provisioning > SNMP tabs.
Step 2
In the Trap Destinations area, click Create.
Step 3
Cisco ONS 15454 SDH Procedure Guide, R7.0
4-12
Card Protection Types (continued)
Cards
TXPP_MR_2.5G
MXPP_MR_2.5G
Any
DLP-D71 Create a 1:1 Protection Group, page 17-62
DLP-D72 Create a 1:N Protection Group, page 17-63
DLP-D73 Create a 1+1 Protection Group, page 17-64
If a protect card is not installed, you can complete the
page 21-33 and continue with the card protection provisioning.
To provision Y-cable protection for TXP and MXP cards, refer to the Cisco ONS 15454 DWDM
Procedure Guide.
This procedure provisions the SNMP parameters so that you can use
SNMP management software with the ONS 15454 SDH.
None
NTP-D24 Verify Card Installation, page 4-2
Required if SNMP is used at your installation.
Onsite or remote
Provisioning or higher
"DLP-D60 Log into CTC" task on page 17-49
Description and Installation Requirements
Splitter protection is automatically provided with the
TXPP_MR_2.5G and MXPP_MR_2.5G cards. For more
information, refer to the Cisco ONS 15454 DWDM Procedure
Guide.
Unprotected cards can cause signal loss if a card fails or
incurs a signal error. However, because no card slots are
reserved for protection, unprotected schemes maximize the
service available for use on the ONS 15454 SDH.
Unprotected is the default protection type.
"DLP-D442 Preprovision a Slot" task on
at the node where you want to set up SNMP.
Chapter 4 Turn Up a Node
78-17194-01