Dlp- D184 View Es-Is Routing Information Base - Cisco ONS 15454 SDH Procedure Manual

Chapter 18 DLPs D100 to D199
•
If additional routers are enabled, you can view their RIBs by choosing the router number in the Router
Step 3
field and clicking Refresh.
Return to your originating procedure (NTP).
Step 4
DLP-D184 View ES-IS Routing Information Base
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Maintenance > OSI > ES-IS RIB tabs.
Step 1
View the following RIB information for Router 1:
Step 2
•
•
•
•
If additional routers are enabled, you can view their RIBs by choosing the router number in the Router
Step 3
field and clicking Refresh.
Return to your originating procedure (NTP).
Step 4
78-17194-01
MAC Address—For destination NEs that are accessed by LAN subnets, the NE's MAC address.
This task allows you to view the End System to Intermediate System
(ES-IS) protocol RIB. ES-IS is an OSI protocol that defines how end
systems (hosts) and intermediate systems (routers) learn about each other.
For ESs, the ES-IS RIB shows the network view from the perspective of the
ES node. For ISs, the ES-IS RIB shows the network view from the
perspective of the IS node.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
Subnet Type—Indicates the OSI subnetwork point of attachment type used to access the destination
address. Subnet types include SDCC, LDCC, GCC, OSC, and LAN.
Location—Indicates the subnet interface. For DCC subnets, the slot and port are displayed. LAN
subnets are shown as LAN.
Destination Address—The destination IS NSAP.
MAC Address—For destination NEs that are accessed by LAN subnets, the NE's MAC address.

DLP- D184 View ES-IS Routing Information Base

Cisco ONS 15454 SDH Procedure Guide, R7.0
18-71