Cisco ONS 15454 SDH Procedure Manual page 37

Hide thumbs Also See for ONS 15454 SDH:

Table of Contents

DLP-D167 Add a Static TID to NSAP Entry to the TARP Data Cache

DLP-D168 Remove a Static TID to NSAP Entry from the TARP Data Cache

DLP-D169 Add a TARP Manual Adjacency Table Entry

DLP-D171 Provision OSI Routers

DLP-D172 Provision Additional Manual Area Addresses

DLP-D173 Enable the OSI Subnet on the LAN Interface

DLP-D174 Create an IP-Over-CLNS Tunnel

DLP-D175 Remove a TARP Manual Adjacency Table Entry

DLP-D176 Convert E1-N-14 Cards From 1:1 to 1:N Protection

DLP-D177 Convert DS3i-N-12 Cards From 1:1 to 1:N Protection

DLP-D178 Change the OSI Routing Mode

DLP-D179 Edit the OSI Router Configuration

DLP-D180 Edit the OSI Subnetwork Point of Attachment

DLP-D181 Edit an IP-Over-CLNS Tunnel

DLP-D182 Delete an IP-Over-CLNS Tunnel

DLP-D183 View IS-IS Routing Information Base

DLP-D184 View ES-IS Routing Information Base

DLP-D185 Manage the TARP Data Cache

DLP-D186 Provision a Low-Order VC11 Circuit Source and Destination

DLP-D187 Provision a Low-Order VC11 Circuit Route

DLP-D188 View CE-Series Ethernet and POS Ports Statistics PM Parameters

DLP-D189 Verify that a 1+1 Working Slot is Active

DLP-D190 View CE-Series Ethernet and POS Ports Utilization PM Parameters

DLP-D191 Delete a Card

DLP-D192 View CE-Series Ethernet and POS Ports History PM Parameters

DLP-D193 Grant Superuser Privileges to a Provisioning User

DLP-D194 Clear an MS-SPRing Force Ring Switch

DLP-D195 Verify Timing in a Reduced Ring

DLP-D196 Delete an MS-SPRing from a Single Node

DLP-D197 Initiate an SNCP Force Switch

DLP-D198 Clear an SNCP Force Switch

DLPs D200 to D299

DLP-D201 Apply a Lock-On

DLP-D202 Apply a Lockout

DLP-D203 Clear a Lock-On or Lockout

Cisco ONS 15454 SDH Procedure Guide, R7.0

Chapters

Table of Contents