Cisco ONS 15454 SDH Procedure Manual page 164

NTP- D258 Provision an Open-Ended SNCP
NTP-D258 Provision an Open-Ended SNCP
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Verify that the fiber is correctly connected to the SNCP trunk (span) STM-N cards at each open-ended
Step 1
SNCP node.
through Slots 12 and 5. Trunk cards at Nodes 2 and 3 are connected to the third-party vendor equipment.
Cisco ONS 15454 SDH Procedure Guide, R7.0
5-34
This procedure provisions ONS 15454 SDH nodes in an open-ended SNCP
connected to a third-party vendor network. This topology allows you to
route a circuit from one ONS 15454 SDH network to another
ONS 15454 SDH network through a third-party network.
None
NTP-D35 Verify Node Turn-Up, page 5-2
As needed
Onsite
Provisioning or higher
Figure 5-11 shows an example. Node 1 is connected to ONS 15454 SDH Nodes 2 and 3
Chapter 5 Turn Up a Network
78-17194-01