Ntp- D229 Replace An In-Service Cross-Connect Card - Cisco ONS 15454 SDH Procedure Manual

Chapter 15 Maintain the Node
Table 15-2 ONS 15454 SDH Timing Report (continued)
Item Description
SSM Indicates the
Quality SSM timing
quality.
SSM Indicates the
Changed date and time of
the last SSM
status change in
MM/DD/YY
HH:MM:SS
format.
Stop. You have completed this procedure.
NTP-D229 Replace an In-Service Cross-Connect Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Do not reach into a vacant slot or chassis while you install or remove a module or a fan. Exposed
Warning
circuitry could constitute an energy hazard. Statement 206
Caution Removing any active card from the ONS 15454 SDH can result in traffic interruption. Use caution when
replacing cards and verify that only standby cards are being replaced. An improper removal
(IMPROPRMVL) alarm is raised when a card reseat is performed, unless the card is first deleted in CTC.
The alarm clears after the card replacement is complete.
Complete the
Step 1
card.
From the View menu, choose Go to Network View.
Step 2
Click the Alarms tab and complete the following substeps:
Step 3
a.
78-17194-01
Options
8 to 10 SSM quality messages
might be displayed.
—
"DLP-D60 Log into CTC" task on page 17-49
Verify that the alarm filter is not on. See the
page 19-25 as necessary.
Option Descriptions
For a list of SSM message sets, see the "Timing" chapter
in the Cisco ONS 15454 SDH Reference Manual.
—
This procedure replaces an in-service (Unlocked-enabled)
cross-connect card.
None
DLP-D333 Install the XC-VXL-10G, XC-VXL-2.5G, or XC-VXC-10G
Cards, page 20-25
As needed
Onsite or remote
Provisioning or higher
"DLP-D227 Disable Alarm Filtering" task on
Cisco ONS 15454 SDH Procedure Guide, R7.0

NTP- D229 Replace an In-Service Cross-Connect Card

at the node where you want to replace the
15-21