Dlp- D29 Change Tunnel Type - Cisco ONS 15454 SDH Procedure Manual

DLP- D29 Change Tunnel Type

Return to your originating procedure (NTP).
Step 10
DLP-D29 Change Tunnel Type
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the View menu, choose Go to Network View.
Step 1
Click the Provisioning > Overhead Circuits tabs.
Step 2
Click the circuit tunnel that you want to convert.
Step 3
Click Edit.
Step 4
In the Edit circuit window, click the Tunnel tab.
Step 5
In the Attributes area, complete the following:
Step 6
•
•
Click Apply.
Step 7
In the confirmation dialog box, click Yes to continue.
Step 8
In the Circuit Changed status box, click OK to acknowledge that the circuit change was successful.
Step 9
Return to your originating procedure (NTP).
Step 10
Cisco ONS 15454 SDH Procedure Guide, R7.0
17-24
This task converts a traditional DCC tunnel to an IP-encapsulated tunnel or
an IP-encapsulated tunnel to a traditional RS-DCC tunnel.
None
DLP-D361 Create a DCC Tunnel, page 20-66
DLP-D4 Create an IP-Encapsulated Tunnel, page 17-3
As needed
Onsite or remote
Provisioning or higher
If you are converting a traditional DCC tunnel to an IP-encapsulated tunnel, check the Change to
IP Tunnel check box and type the percentage of total RS-DCC bandwidth used in the IP tunnel (the
minimum percentage is 10 percent).
If you are converting an IP tunnel to a traditional DCC tunnel, check the Change to RS-DCC
Tunnel check box.
Chapter 17 DLPs D1 to D99
78-17194-01