Table of Contents
Advertisement
DLP- D134 Change the Optical Line Rate on the MRC-12 Card
In the Pluggable Ports area, click Create. The Create Port dialog box appears.
Step 3
In the Create Port dialog box, complete the following:
Step 4
•
•
Table 18-4
Card
MRC-12
Click OK.
Step 5
Repeat Steps
Step 6
Click OK. The row in the Pluggable Ports area turns light blue until the actual SFP is installed and then
Step 7
the row turns white.
Return to your originating procedure (NTP).
Step 8
DLP-D134 Change the Optical Line Rate on the MRC-12 Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the MRC-12 card where you want to provision PPM settings.
Step 1
Click the Provisioning > Pluggable Port Modules tabs.
Step 2
Click the port with the port rate you want to change in the Pluggable Ports area. The highlight changes
Step 3
to dark blue.
Click Edit. The Edit Port Rate dialog box appears.
Step 4
In the Change To field, use the drop-down list to select the new port rate and click OK.
Step 5
Cisco ONS 15454 SDH Procedure Guide, R7.0
18-28
Port—Click the PPM number and port number from the drop-down list. The first number indicates
the PPM and the second number indicates the port number on the PPM. For example, the first PPM
displays as 1-1 and the second PPM displays as 2-1.
Port Type—Click the type of port from the drop-down list. The port type list displays the supported
port rates on your PPM. See
PPM Port Types
3
through
5
to configure the port rates as needed.
This task changes the optical line rate on a multirate PPM. Perform this
task if you want to change the port rate on a multirate SFP that is already
provisioned.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
Table 18-4
for definitions of the supported rates on the MRC-12 card.
Port Type
STM-1—155 Mbps
•
STM-4—622 Mbps
•
STM-16—2.48 Gbps
•
Chapter 18
DLPs D100 to D199
78-17194-01
Advertisement
Chapters
Table of Contents
