Dlp- D4 Create An Ip-Encapsulated Tunnel - Cisco ONS 15454 SDH Procedure Manual

Chapter 17 DLPs D1 to D99
Click Add Span. The span is added to the Included Spans list and the span arrow turns blue.
Step 5
Repeat Steps
Step 6
all intermediary nodes. If Fully Protect Path is checked in the Circuit Routing Preferences area, you must
complete the following steps:
•
•
Return to your originating procedure (NTP).
Step 7
DLP-D4 Create an IP-Encapsulated Tunnel
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Each ONS 15454 SDH can have up to ten IP-encapsulated tunnel connections. Terminated RS-DCCs
Note
used by the ONS 15454 SDH cannot be used as tunnel endpoints, and an RS-DCC that is used as a tunnel
endpoint cannot be terminated. All tunnel connections are bidirectional.
Verify that IP addresses are provisioned at both the source and destination nodes of the planned tunnel.
Step 1
For more information, see the
Step 2 In network view, click the Provisioning > Overhead Circuits tabs.
Step 3 Click Create.
In the Overhead Circuit Creation dialog box, complete the following in the Circuit Attributes area:
Step 4
•
•
•
Click Next.
Step 5
78-17194-01
2 through 5 until the circuit is provisioned from the source to the destination node through
Add two spans for each subnetwork connection protection (SNCP) ring or unprotected portions of
the circuit route from the source to the destination.
Add one span for each multiplex section-shared protection ring (MS-SPRing) or 1+1 portions of the
route from the source to the destination.
This task creates a an IP-encapsulated tunnel to transport traffic from
third-party SDH equipment across ONS 15454 SDH networks.
IP-encapsulated tunnels are created on the Regenerator-Section DCC
(RS-DCC) channel (D1-D3) (if not used by the ONS 15454 SDH as a
terminated data communications channel [DCC]).
For SDH nodes, STM cards must be installed.
For hybrid (SDH and dense wavelength division multiplexing [DWDM])
nodes, optical service channel (OSC) or muxponder (MXP_2.5_10E,
MXP_2.5_10G, MXPP_MR_2.5G, or MXP_MR_2.5G) cards must be
installed.
NTP-D35 Verify Node Turn-Up, page 5-2
As needed
Onsite or remote
Provisioning or higher
Name—Type the tunnel name.
Type—Choose IP Tunnel-D1-D3.
Maximum Bandwidth—Type the percentage of total RS-DCC bandwidth used in the IP tunnel (the
minimum percentage is 10 percent).
"DLP-D249 Provision IP Settings" task on page
Cisco ONS 15454 SDH Procedure Guide, R7.0

DLP- D4 Create an IP-Encapsulated Tunnel

19-52.
17-3