Ntp- D224 Install The Electrical Card Cables On The Fmecs - Cisco ONS 15454 SDH Procedure Manual

NTP- D224 Install the Electrical Card Cables on the FMECs

NTP-D224 Install the Electrical Card Cables on the FMECs
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Caution Always use the supplied ESD wristband when working with a powered ONS 15454 SDH. Plug the
wristband cable into the ESD jack located on the lower-right outside edge of the shelf assembly.
Step 1 Complete the
needed.
Step 2 Complete the
page 20-18
Complete the
Step 3
page 20-20
Continue with the
Step 4
Stop. You have completed this procedure.
NTP-D10 Route Electrical Cables
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
To route coaxial cables, tie wrap or lace the coaxial cables according to local site practice and route the
Step 1
cables through the side cutouts on either side of the ONS 15454 SDH. The rubber-coated edges of the
side cutouts prevent the cables from chafing.
Cisco ONS 15454 SDH Procedure Guide, R7.0
1-16
This procedure installs cables for electrical cards via the FMECs. You will
install the electrical cards in
Cable."
Coaxial cable with 1.0/2.3 miniature coax connectors according to the
electrical traffic cards in use
Shielded 120-ohm cables with connectors according to the electrical traffic
cards in use
NTP-D220 Install the Power and Signal FMECs, page 1-7
As needed
Onsite
None
"DLP-D328 Install 75-Ohm E-1, E-3, or STM-1 Coaxial Cables" task on page 20-17
"DLP-D329 Install 120-Ohm E-1 Cables with DB-37 Connectors to the FMECs" task on
as needed.
"DLP-D330 Install 120-Ohm E-1 Cables with Molex 96-Pin LFH Connectors" task on
as needed.
"NTP-D10 Route Electrical Cables" procedure on page
This procedure routes and manages electrical cables. You will install the
electrical cards in
Coaxial or twister-pair cables
NTP-D224 Install the Electrical Card Cables on the FMECs, page 1-16
As needed
Onsite
None
Chapter 1
Chapter 2, "Install Cards and Fiber-Optic
Chapter 2, "Install Cards and Fiber-Optic Cable."
Install the Shelf and FMECs
as
1-16.
78-17194-01