Ntp-B216 Install The Mechanical Interface Cards; Figure 1-3 Ons 15327 Slot Numbering - Cisco ONS 15327 Procedure Manual

Chapter 1 Install Hardware

NTP-B216 Install the Mechanical Interface Cards

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
Warning
touch the backplane with your hand or any metal tool to avoid the risk of shock.
Install MIC A in Slot 8:
Step 1
a.
b.
c.
d.
The slots are keyed to ensure that cards are installed in the correct slots.
and number of each slot.
Figure 1-3
If you require redundant power, more than 14 DS-1s, or you are using DS-3s, install MIC B in Slot 7.
Step 2
Warning Always make sure power is disconnected before removing MICs from the ONS 15327.
Continue with the
Step 3
Stop. You have completed this procedure.
March 2003
This procedure installs the two Mechanical Interface cards (MICs) in Slots
7 and 8.
None
NTP-B2 Install the Shelf Assembly, page 1-5
Required
Onsite
None
Open the card ejectors.
Slide the card along the guide rails into the slot.
Close the ejectors.
Lock the cards into place by tightening the ejector locking screws.
ONS 15327 Slot Numbering
Slot 4
Slot 3
Slot 2
Slot 1
"NTP-B6 Install the Power and Ground" procedure on page
Slot 5
4
Slot 6
3
Slot 7
2
Slot 8
1
NTP-B216 Install the Mechanical Interface Cards
Figure 1-3 shows the location
1-12.
Cisco ONS 15327 Procedure Guide, R4.0
5
Fan
Tray
6
Slot
7
8
1-11