Dlp- D222 Provision G-Series Ethernet Ports - Cisco ONS 15454 SDH Procedure Manual

Chapter 19 DLPs D200 to D299
DLP-D222 Provision G-Series Ethernet Ports
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the G-Series card graphic to open the card.
Step 1
Click the Provisioning > Port tabs.
Step 2
For each G-Series port, provision the following parameters:
Step 3
•
•
•
•
•
•
An Encapsulation Mismatch Path alarm appears when a point-to-point circuit is created between two
Note
Ethernet card ports with incompatible Encapsulation payload types.
Click Apply.
Step 4
Step 5 Refresh the Ethernet statistics:
a.
b.
78-17194-01
This task provisions G-Series Ethernet ports.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
Port Name—If you want to label the port, type the port name.
Admin State—Complete the
Auto Negotiation—Click this check box to enable autonegotiation on the port (default). If you do
not want to enable autonegotiation control, uncheck the box.
Flow Control—Click this check box to enable flow control on the port (default). If you do not want
to enable flow control, uncheck the box. To set custom flow control watermarks, see the
Provision G-Series Flow Control Watermarks" task on page
Max Size—To permit the acceptance of jumbo size Ethernet frames, choose Jumbo (default). If you
do not want to permit jumbo size Ethernet frames, choose 1548.
The maximum frame size of 1548 bytes enables the port to accept valid Ethernet frames that
Note
use protocols, such as Inter-Switch Link (ISL) protocol. ISL adds 30 bytes of overhead and
might cause the frame size to exceed the traditional 1518 byte maximum.
Payload Type—Click in the Payload Type field and select a cyclic redundancy check (CRC) size to
set the G-Series card's LEX encapsulation:
LEX-FCS-16 is 16-bit (2 byte) CRC.
–
– LEX-FCS-32 is 32-bit (4 byte) CRC.
Click the Performance > Statistics tabs.
Click the Refresh button.
"DLP-D214 Change the Service State for a Port" task on page
Cisco ONS 15454 SDH Procedure Guide, R7.0

DLP- D222 Provision G-Series Ethernet Ports

20-58.
19-10.
"DLP-D353
19-21