Ntp- D153 Reset A Card Using Ctc - Cisco ONS 15454 SDH Procedure Manual

NTP- D153 Reset a Card Using CTC

NTP-D153 Reset a Card Using CTC
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Do not reach into a vacant slot or chassis while you install or remove a module or a fan. Exposed
Warning
circuitry could constitute an energy hazard. Statement 206
Complete the
Step 1
software reset. If you are already logged in, continue with Step 2.
Step 2 Complete the
Complete the
Step 3
card, electrical card, FC_MR-4 card, or G-Series, E-Series, CE-1000-4, or ML-Series Ethernet card.
Step 4 Complete the
Step 5 Complete the
Stop. You have completed this procedure.
NTP-D215 View G-Series Ethernet Maintenance Information
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Step
Cisco ONS 15454 SDH Procedure Guide, R7.0
15-16
This procedure resets TCC2/TCC2P, electrical, optical, Ethernet, and
FC_MR-4 cards.
None
One of the following procedures:
•
•
•
•
•
As needed
Onsite or remote
Superuser
"DLP-D60 Log into CTC" task on page 17-49
"DLP-D37 Reset a TCC2/TCC2P Card Using CTC" task on page 17-29
"DLP-D38 Reset a Traffic Card in CTC" task on page 17-30
"DLP-D102 Hard-Reset a CE-100T-8 Card Using CTC" task on page 18-2
"DLP-D103 Soft-Reset a CE100T-8 Card Using CTC" task on page 18-3
This procedure enables you to view loopback, bandwidth, and J1 path
trace information on a selected G-Series Ethernet card.
None
NTP-D18 Install Ethernet Cards and Connectors, page 2-11
As needed
Onsite or remote
Retrieve or higher
"DLP-D60 Log into CTC" task on page
2.
DLP-D332 Install the TCC2/TCC2P Cards, page 20-22
NTP-D16 Install STM-N Cards and Connectors, page 2-7
NTP-D17 Install the Electrical Cards, page 2-10
NTP-D18 Install Ethernet Cards and Connectors, page 2-11
NTP-D286 Install the FC_MR-4 Cards, page 2-12
17-49. If you are already logged in, continue with
Chapter 15 Maintain the Node
at the node where you are performing the
as needed.
as needed to reset an optical
as needed.
as needed.
78-17194-01