Dlp- D188 View Ce-Series Ethernet And Pos Ports Statistics Pm Parameters - Cisco ONS 15454 SDH Procedure Manual

Hide thumbs Also See for ONS 15454 SDH:
Table of Contents

Advertisement

Chapter 18
DLPs D100 to D199
Starting with a span on the source node, click the arrow of the span you want the circuit to travel. The
Step 2
arrow turns white. In the Selected Span area, the From and To fields provide span information. The
source VC11 appears.
If you want to change the source VC11, adjust the Source VC11 field; otherwise, continue with
Step 3
Step 4
If you want to change the source TUG2, TUG3, VC3, or VC4, adjust the TUG2, TUG3, VC3, or VC4
fields; otherwise, continue with
Click Add Span. The span is added to the Included Spans list and the span arrow turns blue.
Step 5
Repeat Steps
Step 6
all intermediary nodes. If Fully Protect Path is checked in the Circuit Routing Preferences area, you must
complete the following steps:
Return to your originating procedure (NTP).
Step 7
DLP-D188 View CE-Series Ethernet and POS Ports Statistics PM Parameters
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note
For CE-Series card provisioning, refer to the Ethernet Card Software Feature and Configuration Guide
for the Cisco ONS 15454, Cisco ONS 15454 SDH, and Cisco ONS 15327.
Step 1
In node view, double-click the CE-Series Ethernet card where you want to view PM counts. The card
view appears.
Step 2
Click the Performance > Ether Ports > Statistics
Statistics tabs.
78-17194-01
2
through
5
until the circuit is provisioned from the source to the destination node through
Add two spans for all SNCP ring or unprotected portions of the circuit route from the source to the
destination.
Add one span for all MS-SPRing or 1+1 portions of the route from the source to the destination.

DLP- D188 View CE-Series Ethernet and POS Ports Statistics PM Parameters

Step
5.
This task enables you to view CE-Series card Ethernet and POS port
Statistics PM counts at selected time intervals to detect possible
performance problems.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Retrieve or higher
(Figure
Cisco ONS 15454 SDH Procedure Guide, R7.0
18-12) or Performance > POS Ports >
Step
4.
18-75

Advertisement

Table of Contents
loading

Table of Contents