Dlp- D257 View Ethernet Utilization Pm Parameters - Cisco ONS 15454 SDH Procedure Manual

DLP- D257 View Ethernet Utilization PM Parameters

View the PM parameter names in the Param column. The current PM parameter values appear in the
Step 5
Port # columns. For PM parameter definitions, refer to the "Performance Monitoring" chapter in the
Cisco ONS 15454 SDH Reference Manual.
Note
Step 6 Return to your originating procedure (NTP).
DLP-D257 View Ethernet Utilization PM Parameters
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the E-Series or G-Series Ethernet card where you want to view PM counts.
Step 1
The card view appears.
Step 2 Click the Performance > Utilization tabs.
Step 3 Click Refresh. Performance monitoring utilization values appear for each port on the card.
View the Port # column to find the port you want to monitor.
Step 4
The Tx and Rx bandwidth utilization values for the previous time intervals appear in the Prev-n columns.
Step 5
For PM parameter definitions, refer to the "Performance Monitoring" chapter in the
Cisco ONS 15454 SDH Reference Manual.
Note
Step 6 Return to your originating procedure (NTP).
Cisco ONS 15454 SDH Procedure Guide, R7.0
19-62
To clear PM counts, see "DLP-D459 Clear Selected PM Counts" task on page
This task enables you to view line utilization PM counts on an Ethernet
card and port in order to detect possible performance problems.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Retrieve or higher
To clear PM counts, see the "DLP-D459 Clear Selected PM Counts" task on page
Chapter 19 DLPs D200 to D299
21-36.
21-36.
78-17194-01