Ntp- D262 Set Up A Remote Access Connection To The Ons 15454 Sdh - Cisco ONS 15454 SDH Procedure Manual

NTP- D262 Set Up a Remote Access Connection to the ONS 15454 SDH

NTP-D262 Set Up a Remote Access Connection to the
ONS 15454 SDH
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Connect the modem to the RJ-45 (LAN) port on the TCC2/TCC2P card or the RJ-45 jack on the
Step 1
MIC-C/T/P FMEC.
While referring to the modem documentation, complete the following tasks to provision the modem for
Step 2
the ONS 15454 SDH:
•
•
•
Continue with the
Step 3
Stop. You have completed this procedure.
Cisco ONS 15454 SDH Procedure Guide, R7.0
3-6
This procedure connects the CTC computer to an ONS 15454 SDH using a
LAN modem.
Modem and modem documentation. The modem must be:
•
•
•
NTP-D278 Set Up Computer for CTC, page 3-2
As needed
Onsite or remote
None
For CTC access, set the modem for Ethernet access.
Assign an IP address to the modem that is on the same subnet as the ONS 15454 SDH.
The IP address the modem assigns to the CTC computer must be on the same subnet as the modem
and the ONS 15454 SDH.
"NTP-D23 Log into the ONS 15454 SDH GUI" procedure on page
Connected to the ONS 15454 SDH
Provisioned for the ONS 15454 SDH
Provisioned for Ethernet access to run CTC
Chapter 3 Connect the PC and Log into the GUI
3-7.
78-17194-01