Dlp- D358 Change A Multiplex-Section Dcc Termination - Cisco ONS 15454 SDH Procedure Manual

Chapter 20 DLPs D300 to D399
DLP-D358 Change a Multiplex-Section DCC Termination
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Click the Provisioning > Comm Channels > MS-DCC tabs.
Step 2 Click the MS-DCC that you want to change.
Click Edit.
Step 3
In the MS-DCC Termination Editor dialog box, complete the following as necessary:
Step 4
•
•
•
Step 5 Click OK.
Return to your origination procedure (NTP).
Step 6
DLP-D359 Change a Regenerator-Section DCC Termination
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Click the Provisioning > Comm Channels > RS-DCC tabs.
Step 1
Click the RS-DCC that you want to change.
Step 2
Click Edit.
Step 3
78-17194-01
This task modifies a multiplex-section data communications channel
(MS-DCC). You can also enable or disable Open Shortest Path First
(OSPF) and enable or disable the foreign node setting.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
Disable OSPF on MS-DCC Link—If checked, OSPF is disabled on the link. OSPF should be
disabled only when the slot and port connect to third-party equipment that does not support OSPF.
Far End is Foreign—Check this box to specify that the MS-DCC termination is a non-ONS node.
Far end IP—If you checked the Far End is Foreign check box, type the IP address of the far-end node
or leave the 0.0.0.0 default. An IP address of 0.0.0.0 means that any address can be used by the far
end.
This task modifies a regenerator-section DCC (RS-DCC). You can also
enable or disable OSPF and enable or disable the foreign node setting.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher

DLP- D358 Change a Multiplex-Section DCC Termination

Cisco ONS 15454 SDH Procedure Guide, R7.0
20-65