Dlp- D18 Turn On And Verify Office Power - Cisco ONS 15454 SDH Procedure Manual

DLP- D18 Turn On and Verify Office Power

When terminating power, return, and frame ground, do not use soldering lug connectors, screwless
Caution
(push-in) connectors, quick-connect connectors, or other friction-fit connectors.
If the system loses power or if both TCC2/TCC2P cards are reset, you must reset the ONS 15454 SDH
Note
clock. After powering down, the date defaults to January 1, 1970, 00:04:15. To reset the clock, see the
"NTP-D316 Set Up Name, Date, Time, and Contact Information" procedure on page
Verify that the MIC-A/P Front Mount Electrical Connection (FMEC) card is installed in Slot 23 and the
Step 1
MIC-C/T/P FMEC card is installed in Slot 24 of the Electrical Facility Connection Assembly (EFCA).
Attach the connector on the end of the power cable to the power FMEC.
Step 2
Tighten the screws of the connector on the power cable.
Step 3
Connect the power cable to the fuse panel or power source. Use the pin connections in
Step 4
Do not use the yellow and green conductor wire for secondary grounding. This wire will be removed in
Caution
a future release.
Table 17-1
Pin
A1
A2
A3
Return to your originating procedure (NTP).
Step 5
DLP-D18 Turn On and Verify Office Power
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Do not apply power to the ONS 15454 SDH until you complete all installation steps.
Caution
Cisco ONS 15454 SDH Procedure Guide, R7.0
17-16
Pin Connection of the Power FMECs
Function
Battery return
–48 V battery
Ground
This task measures the power to verify correct power and returns.
Voltmeter
DLP-D16 Connect the Office Ground to the ONS 15454 SDH, page 17-13
DLP-D17 Connect Office Power to the ONS 15454 SDH Shelf, page 17-15
Required
Onsite
None
Cable Color
Black
Red
Green with yellow stripes
Chapter 17 DLPs D1 to D99
4-4.
Table 17-1.
78-17194-01