Dlp- D235 Roll One Cross-Connect From An Optical Circuit To A Second Optical Circuit - Cisco ONS 15454 SDH Procedure Manual

Chapter 19 DLPs D200 to D299
Figure 19-8
Step 12 If you selected Manual in
you selected Auto, continue with
Step 13 For both Manual and Auto rolls, click Finish to complete the circuit roll process. The roll clears from
the Rolls tab and the rolled circuit now appears on the Circuits tab in the DISCOVERED status.
Return to your originating procedure (NTP).
Step 14
DLP-D235 Roll One Cross-Connect from an Optical Circuit to a Second Optical
Circuit
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the View menu, choose Go To Network View.
Step 1
Click the Circuits tab.
Step 2
Press Ctrl and click the two circuits that you want to use in the roll process.
Step 3
The circuits must have a DISCOVERED status; in addition, they must be the same size and direction for
you to start a roll. The planned Roll To circuit must not carry traffic. The Roll To facility should be DCC
connected to the source node of the Roll To circuit.
From the Tools menu, choose Circuits > Roll Circuit.
Step 4
In the Roll Attributes area, complete the following
Step 5
a.
78-17194-01
Viewing the Rolls Tab
Step
This task reroutes a cross-connect on one circuit onto another circuit,
resulting in a new destination.
None
DLP-D60 Log into CTC, page 17-49
DLP-D363 Provision Regenerator-Section DCC Terminations, page 20-68
for the ports involved in the roll
As needed
Onsite or remote
Provisioning or higher
From the Circuit Roll Mode drop-down list, choose Auto to create an automatic roll (required for a
1-way source roll) or Manual to create a manual roll (required for 1-way destination roll).

DLP- D235 Roll One Cross-Connect from an Optical Circuit to a Second Optical Circuit

5, click the rolled facility on the Rolls tab and then click Complete. If
Step 13.
(Figure
Cisco ONS 15454 SDH Procedure Guide, R7.0
19-9):
19-33