Ntp- D241 Provision G-Series Ports For Transponder Mode - Cisco ONS 15454 SDH Procedure Manual

NTP- D241 Provision G-Series Ports for Transponder Mode

b.
c.
Click Next.
Step 12
Provision the circuit destination:
Step 13
a.
b.
c.
Click Next.
Step 14
Verify the cross-connect information (in this step, "circuit" refers to the cross-connect):
Step 15
•
•
•
•
If the information is not correct, click the Back button and repeat the procedure with the correct
information. If the information is correct, check Route Automatically.
Complete the
Step 16
complete the
Click Finish.
Step 17
Stop. You have completed this procedure.
NTP-D241 Provision G-Series Ports for Transponder Mode
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
G-Series ports. If you are already logged in, continue with
In the node view, double-click the G-Series card graphic to open the card.
Step 2
Click the Provisioning > Port tabs.
Step 3
To put a pair of G-Series card ports in two-port bidirectional transponder mode
Step 4
Cisco ONS 15454 SDH Procedure Guide, R7.0
6-92
From the Slot drop-down list, choose the Ethernet card that will be the cross-connect source.
From the Port drop-down list, choose the cross-connect source port.
From the Node drop-down list, choose the cross-connect source node selected in
Ethernet cross-connects, the source and destination nodes are the same.)
From the Slot drop-down list, choose the STM-N card that connects to the non-ONS equipment.
Depending on the STM-N card, choose the port and VC4 from the Port and VC4 drop-down lists.
Circuit name
Circuit type
Circuit size
ONS 15454 SDH circuit nodes
"NTP-D149 Test G-Series Circuits" procedure on page 6-95
"NTP-D146 Test E-Series Circuits" procedure on page 6-89
This task provisions G-Series ports for transponder mode.
None
DLP-D222 Provision G-Series Ethernet Ports, page 19-21
As needed
Onsite or remote
Provisioning or higher
"DLP-D60 Log into CTC" task on page 17-49
Chapter 6 Create Circuits and Low-Order Tunnels
for a G-Series card, or
for an E-Series card.
at the node where you will provision
Step 2.
(Figure
Step 11. (For
6-10):
78-17194-01