Cisco ONS 15454 SDH Procedure Manual page 646

DLP- D244 Use the Reinitialization Tool to Clear the Database and Upload Software (Windows)
User ID—Enter the user ID needed to access the node.
•
Password—Enter the password for the user ID.
•
Upload Package—Check this box to send the software package file to the node. If unchecked, the
•
software stored on the node is not modified.
Force Upload—Check this box to send the software package file to the node even if the node is
•
running the same software version. If unchecked, reinitialization will not send the software package
if the node is already running the same version.
Activate/Revert—Check this box to activate the uploaded software (if the software version is later
•
than the one installed) or revert to the uploaded software (if the software version is earlier than the
one installed) as soon as the software file is uploaded. If unchecked, the software is not activated or
reverted after the upload, allowing you to initiate the functions later from the node view
Maintenance > Software tab.
Re-init Database—Check this box to send a new database to the node. (This is equivalent to the CTC
•
database restore operation.) If unchecked, the node database is not modified.
• Confirm—Check this box if you want a warning message displayed before any operation is
performed. If unchecked, reinitialization does not display a warning message.
• Search Path—Enter the path to the CISCO15454SDH folder on the CD drive.
Step 6 Click Go.
Before continuing with the next step, verify that the database to upload is correct. You cannot reverse
Caution
the upload process after you click Yes.
Review the information on the Confirm NE Re-Initialization dialog box, then click Yes to start the
Step 7
reinitialization.
The reinitialization begins. After the software is downloaded and activated, and the database is uploaded
to the TCC2/TCC2P cards, "Complete" appears in the status bar and the TCC2/TCC2P cards will reboot.
Wait a few minutes for the reboot to complete.
After the reboot is complete, log into the node using the
Step 8
Complete the
Step 9
and the
node name, IP address, subnet mask and gateway, and Internet Inter-ORB Protocol (IIOP) port.
Step 10 Return to your originating procedure (NTP).
Cisco ONS 15454 SDH Procedure Guide, R7.0
19-48
"NTP-D316 Set Up Name, Date, Time, and Contact Information" procedure on page 4-4
"NTP-D169 Set Up CTC Network Access" procedure on page 4-7
Chapter 19
"DLP-D60 Log into CTC" task on page
for information on setting the
DLPs D200 to D299
17-49.
78-17194-01