Figure 18-7 Enabling Or Disabling Pointer Justification Count Parameters; Table 18-3 Traffic Cards That Terminate The Line (Ltes) - Cisco ONS 15454 SDH Procedure Manual

DLP- D121 Enable Pointer Justification Count Performance Monitoring
Table 18-3
Line Terminating Equipment
OC192 SR/STM64 IO 1310
OC192 IR/STM64 SH 1550
OC192 LR/STM64 LH 1550
OC192 ELR/STM64 LH ITU 15xx.xx
Click the Provisioning > Line tabs.
Step 3
Click the PJVC4Mon# drop-down list and make a selection based on the following rules
Step 4
Off means pointer justification monitoring is disabled (default).
•
Values 1 to n are the number of VC4s on the port. One VC4 per port can be enabled from the
•
PJVC4Mon# card drop-down list.
Figure 18-7
Line tab
Step 5 In the Service State field, confirm that the port is in the Unlocked-enabled service state.
If the port is Unlocked-enabled, click Apply. If the port is out of service (Locked-enabled,disabled;
Step 6
Locked-enabled,maintenance; Unlocked-disabled,automaticInService), choose Unlocked in the Admin
State drop-down list and click Apply.
Cisco ONS 15454 SDH Procedure Guide, R7.0
18-20
Traffic Cards that Terminate the Line (LTEs) (continued)
Enabling or Disabling Pointer Justification Count Parameters
Provisioning tab Card view PJVC4Mon#
Chapter 18 DLPs D100 to D199
(Figure 18-7):
78-17194-01