Ntp- D82 Create A Manually Routed Low-Order Vc12 Circuit - Cisco ONS 15454 SDH Procedure Manual

NTP- D82 Create a Manually Routed Low-Order VC12 Circuit

•
In the Circuits window, verify that the new circuits appear in the circuits list.
Step 20
Step 21 Complete the
a test circuit.
Stop. You have completed this procedure.
NTP-D82 Create a Manually Routed Low-Order VC12 Circuit
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
where you will create the circuit. If you are already logged in, continue with Step 2.
Step 2 Complete the following:
a.
b.
Step 3 If you want to assign a name to the circuit source and destination ports before you create the circuit,
complete the
automatically based on circuit type, node name, and sequence number, continue with
From the View menu, choose Go to Network View.
Step 4
Click the Circuits tab, then click Create.
Step 5
In the Circuit Creation dialog box, complete the following fields:
Step 6
•
•
•
Click Next.
Step 7
Define the circuit attributes
Step 8
Cisco ONS 15454 SDH Procedure Guide, R7.0
6-24
If you entered more than 1 in the Number of Circuits field and did not choose Auto-ranged, the
Circuit Creation dialog box appears so you can create the remaining circuits. Repeat Steps
through 18 for each additional circuit. After completing the circuits, the Circuits window appears.
"NTP-D135 Test Low-Order Circuits" procedure on page
This procedure creates low-order VC12 circuit and allows you to provision
the circuit route.
XC-VXC-10G, XC-VXL-10G, or XC-VXL-2.5G cards must be installed
at the circuit source and destination nodes.
NTP-D127 Verify Network Turn-Up, page 6-5
As needed
Onsite or remote
Provisioning or higher
"DLP-D60 Log into CTC" task on page 17-49
On the shelf graphic, verify that XC-VXC-10G, XC-VXL-10G, or XC-VXL-2.5G cross-connect
cards are installed in Slots 8 and 10.
Click the Provisioning > Cross-Connect tabs and set the Low Order Payload Type to VC-12 or
VC-11 and VC-12 (Mixed Mode).
"DLP-D314 Assign a Name to a Port" task on page
Circuit Type—Choose VC_LO_PATH_CIRCUIT.
Number of Circuits—Enter the number of VC12 circuits that you want to create. The default is 1. If
you are creating multiple circuits with the same slot and consecutive port numbers, you can use
Auto-ranged to create the circuits automatically.
Auto-ranged—This check box is automatically checked if you enter more than 1 in the Number of
Circuits field. Auto-ranging creates identical (same source and destination), sequential circuits
automatically. Uncheck the box if you do not want CTC to create sequential circuits automatically.
(Figure 6-1 on page
Chapter 6 Create Circuits and Low-Order Tunnels
6-53. Skip this step if you built
at an ONS 15454 SDH on the network
20-7. If you want CTC to assign a name
6-9):
6
Step 4.
78-17194-01