Ntp- D17 Install The Electrical Cards - Cisco ONS 15454 SDH Procedure Manual

NTP- D17 Install the Electrical Cards

The MRC-12 card requires SFPs and the STM64-XFP cards require XFPs to provide a fiber interface. If
Step 7
you installed any of these cards, complete the
page 20-28
task on page
Continue with the
Step 8
Stop. You have completed this procedure.
NTP-D17 Install the Electrical Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Warning During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
The E3-12 card can be deployed in a central office or a carrier's exchange.
Note
Note Install higher-capacity cards first; for example, install an E3-12 card before installing an E1-14 card. Let
each card boot completely before installing the next card.
Cisco recommends installing STM-N, transponder (TXP), and muxponder (MXP) cards before you
Note
install electrical cards, as applicable.
If you installed XC-VXL-2.5G cards, review
Step 1
If you installed XC-VXL-10G or XC-VXC-10G cards, review
card/slot compatibility.
Open the card latches/ejectors.
Step 2
Use the latches/ejectors to firmly slide the card along the guide rails until the card plugs into the
Step 3
receptacle at the back of the slot.
Note
Cisco ONS 15454 SDH Procedure Guide, R7.0
2-10
or preprovision the SFP/XFP using the
18-8.
"NTP-D19 Install Fiber-Optic Cables on Optical Cards" procedure on page
This procedure installs the electrical cards (DS3i-N-12, E1-N-14, E1-42,
E3-12, and STM1E-12).
Electrical cards
NTP-D220 Install the Power and Signal FMECs, page 1-7
NTP-D15 Install the Common Control Cards, page 2-2
As needed
Onsite
None
If you install the wrong card in a slot, complete the
procedure on page 2-20.
Chapter 2
"DLP-D335 Install GBIC or SFP/XFP Devices" task on
"DLP-D107 Preprovision an SFP or XFP Device"
Table 2-1 on page 2-3 to determine card/slot compatibility.
Table 2-2 on page 2-5
"NTP-D227 Remove and Replace a Card"
Install Cards and Fiber-Optic Cable
2-16.
to determine
78-17194-01