Ntp- D94 Upgrade Stm-N Cards And Spans Automatically - Cisco ONS 15454 SDH Procedure Manual

Chapter 12 Upgrade Cards and Spans
If your active TCC2 card resets during the upgrade before the new TCC2P card has come to a full standby
Caution
mode, remove the new TCC2P card immediately.
When the newly installed TCC2P card is in standby, go to the active TCC2 and right-click the card.
Step 7
From the shortcut menu, click Reset Card.
Step 8
Wait for the TCC2 card to reboot. The ONS 15454 switches the standby TCC2P card to active mode.
The TCC2 card verifies that it has the same database as the TCC2P card and then switches to standby.
Verify that the remaining TCC2 card is now in standby mode (the ACT/STBY LED changes to amber).
Step 9
Perform
Step 10
The ONS 15454 boots up the second TCC2P card. The second TCC2P card must also copy the database,
which can take approximately 10 minutes. Do not remove the card from the shelf during a database
transfer.
If power-related alarms occur after the second TCC2P card is installed, complete the
Step 11
Measure Voltage" task on page
information about clearing alarms.
Stop. You have completed this procedure.
NTP-D94 Upgrade STM-N Cards and Spans Automatically
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Warning Do not reach into a vacant slot or chassis while you install or remove a module or a fan. Exposed
circuitry could constitute an energy hazard. Statement 206
Optical transmit and receive levels should be in their acceptable range as shown in the specifications
Note
section for each card in
Do not perform any other maintenance operations or add any circuits during a span upgrade.
Caution
78-17194-01
Step 6 to physically replace the remaining TCC2 card with the second TCC2P card.
17-26. Refer to the Cisco ONS 15454 SDH Troubleshooting Guide for
This procedure upgrades cards and STM-N speeds within MS-SPRings,
SNCPs, and 1+1 (linear) protection groups using the Span Upgrade
wizard.
Replacement cards
The span upgrade procedure requires at least two technicians (one at
each end of the span) who can communicate with each other during the
upgrade.
As needed
Onsite
Provisioning or higher
Table 2-4 on page

NTP- D94 Upgrade STM-N Cards and Spans Automatically

2-17.
Cisco ONS 15454 SDH Procedure Guide, R7.0
"DLP-D33
12-7