Dlp- D142 Modify A Static Route - Cisco ONS 15454 SDH Procedure Manual

DLP- D142 Modify a Static Route

You can provision SONET CCAT or VCAT circuits for the CE-100T-8 or CE-1000-4 before or after
Note
provisioning the card's Ethernet and/or POS ports. See the
High-Order Circuit" procedure on page 6-55
Circuit" procedure on page
Step 1 In node view, double-click the CE-100T-8 or CE-1000-4 card graphic to open the card.
Step 2 Click the Provisioning > POS Ports tabs.
Step 3 For each CE-100T-8 or CE-1000-4 port, provision the following parameters:
•
Note
•
•
•
Click Apply.
Step 4
Refresh the POS statistics:
Step 5
a.
b.
Return to your originating procedure (NTP).
Step 6
DLP-D142 Modify a Static Route
Purpose
Tools/Equipment
Cisco ONS 15454 SDH Procedure Guide, R7.0
18-34
6-97, as needed.
Port Name—If you want to label the port, enter the port name.
Circuit table displays port name of the POS port and not the Ethernet port.
Admin State—Choose Unlocked to put the port in service.
Framing Type—Choose GPF-F POS framing (the default) or HDLC POS framing. The framing
type needs to match the framing type of the POS device at the end of the SONET circuit.
Encap CRC—With GFP-F framing, the user can configure a 32-bit cyclic redundancy check (CRC)
(the default) or none (no CRC). HDLC framing provides a set 32-bit CRC. The CRC should be set
to match the CRC of the POS device on the end of the SONET circuit.
Note For more details about the interoperability of ONS Ethernet cards, including information on
encapsulation, framing, and CRC, refer to the "POS on ONS Ethernet Cards" chapter of the
Ethernet Card Software Feature and Configuration Guide for the Cisco ONS 15454,
Cisco ONS 15454 SDH, and Cisco ONS 15327.
The CE-100T-8 and CE-1000-4 cards use LEX encapsulation, which is the primary POS
Note
encapsulation used in ONS Ethernet cards.
Click the Performance > POS Ports > Statistics tabs.
Click Refresh.
This task modifies a static route on an ONS 15454 SDH.
None
"NTP-D323 Create an Automatically Routed
or the "NTP-D283 Create an Automatically Routed VCAT
Chapter 18 DLPs D100 to D199
78-17194-01