Cisco ONS 15454 SDH Procedure Manual page 297

Chapter 8 Monitor Performance
NTP-D195 Monitor Electrical Performance
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
are already logged in, continue with
In node view, double-click the electrical card where you want to view PM counts. The card view appears.
Step 2
Click the Performance tab
Step 3
Figure 8-1
Card View
Performance
radio buttons
Directions
radio buttons
78-17194-01
This procedure enables you to view node near-end or far-end
performance during selected time intervals on an electrical card and port
to detect possible performance problems.
None
Before you monitor performance, be sure you have created the
appropriate circuits and provisioned the card according to your
specifications. For more information, see
and Low-Order Tunnels"
As needed
Onsite
Retrieve or higher
"DLP-D60 Log into CTC" task on page 17-49
(Figure
Viewing Performance Monitoring Information
tab
Intervals
and
Step 2.
8-1).
Port Refresh
drop-down list button
Cisco ONS 15454 SDH Procedure Guide, R7.0
NTP- D195 Monitor Electrical Performance
Chapter 6, "Create Circuits
Chapter 10, "Change Card Settings."
at the node that you want to monitor. If you
Auto-refresh Baseline
drop-down list button
Clear
button
8-3