NTP- D222 Install the E1-75/120 Conversion Panel
Figure 1-3
Align the screw holes on the mounting ears with the mounting holes in the rack.
Step 2
Install one mounting screw in each side of the assembly.
Step 3
When the E1-75/120 conversion panel is secured to the rack, install the remaining mounting screws if
Step 4
necessary.
Continue with the
Step 5
procedure on page
Stop. You have completed this procedure.
Cisco ONS 15454 SDH Procedure Guide, R7.0
1-14
Mounting the E1-75/120 Conversion Panel in a Rack
Equipment rack
"NTP-D223 Attach Wires to Alarm, Timing, LAN, and Craft Pin Connections"
1-15.
Chapter 1
Install the Shelf and FMECs
78-17194-01