Appendix A Ctc Information And Shortcut - Cisco ONS 15454 SDH Procedure Manual

Revision History
Date
March 2007
August 2007
September 2007
Novemver 2007
April 2008
September 2008
November 2008
March 2009
June 2009
August 2009
October 2009
November 2009
Cisco ONS 15454 SDH Procedure Guide, R7.0
xiv
Notes
Revision History Table added for the first time
Corrected product part numbers for the UBIC-V and UBIC-H DS3 cables.
Added in DLP-D121 step to enable IPPM
Updated About this Guide chapter.
Added a note after steps in the section "DLP-D255 Cross-Connect Card Side
Switch Test" in the "DLPs D200 to D299" chapter.
Added NTP-A360 Enable EMS Secure Access in the Turn up a Node chapter.
Added a Note in the sections, DLP-D69 and DLP-D73 in the DLPs D1 to D99
chapter.
Modified a note in Chapter 1, Install the Shelf and FMECs, section Install the
Shelf and Assembly.
Modified a note under Chapter 12, Upgrade Cards and Spans, sections NTP-234
Upgrade the XC-VXL-2.5G Card to the XC-VXL-10G or XC-VXC-10G Card and
NTP-D333 Upgrade the XC-VXL-10G Card to the XC-VXC-10G Card.
Updated fuse rating in NTP-D6 of Chapter 1, Install the Shelf and FMECs and
DLP-D5, DLP-D6, and DLP-D18 of Chapter 17, DLPs D1 to D99.
Added a note in NTP-D333 Upgrade the XC-VXL-10G Card to the XC-VXC-10G
Card in Chapter 12, Upgrade Cards and Spans.
Added new DLPs A596 and A597.
•
Added a note on displayof port name in circuit table in the procedures to
•
provision Ethernet and POS ports for CE-Series and ML Series cards.
Removed references to AIP in the following sections:
• Table 20-32 in Chapter 20 DLPs D300 to D399
• DLP-D432 section in Chapter 21 DLPs D400 to D499
Table A-3 section in Appendix A CTC Information and Shortcuts
•
Updated the size of power cables in Chapter 1, Install the Shelf and FMECs and
Chapter 17, DLPs D1 to D99.
Updated the "Add an SNCP Node" procedure in Chapter 14, "Add and Remove
Node".
Updated the Clean Fiber Connectors procedure in Chapter 15, "Maintain the
•
Node".
Added the "Clean Multi Fiber-Optic Cable Connectors" procedure in Chapter
•
19, DLPs D200 to D299.
Added a note in the sections "Create a 1:1 Protection Group," "Create a 1:N
•
Protection Group," and "Create a 1+1 Protection Group" in the Chapter 17,
DLPs D1 to D99.
Updated the section "NTP-D350 Create a Server Trail" in the chapter, "Create
•
Circuits and Low-Order Tunnels".
Added a note in the "Delete a PPM from the MRC-12 or STM64-XFP Card"
•
procedure in the chapter "DLPs D100 to D199".
About this Guide
78-17194-01