Table of Contents
Advertisement
NTP- D279 Set Power Monitor Thresholds
•
•
Step 4
Click Apply.
Step 5
In the confirmation dialog box, click Yes.
Review the node information. If you need to make corrections, repeat Steps
Step 6
corrections. If the information is correct, continue with the
procedure on page
Stop. You have completed this procedure.
NTP-D279 Set Power Monitor Thresholds
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
already logged in, continue with Step 2.
Step 2
In node view, click the Provisioning > General > Power Monitor tabs.
Step 3
To change the extreme low battery voltage threshold in 0.5 VDC increments, choose a voltage from the
ELWBATVG(Vdc) drop-down list.
Step 4
To change the low battery voltage threshold in 0.5 VDC increments, choose a voltage from the
LWBATVG(Vdc) drop-down list.
To change the high battery voltage threshold in 0.5 VDC increments, choose a voltage from the
Step 5
HIBATVG(Vdc) drop-down list.
To change the extreme high battery voltage threshold in 0.5 VDC increments, choose a voltage from the
Step 6
EHIBATVG(Vdc) drop-down list.
Cisco ONS 15454 SDH Procedure Guide, R7.0
4-6
To change the global date format from American to European, select the appropriate format
Note
on the General tab of the CTC Preferences window. American format is mm/dd/yyyy, for
example, September 24, 2004 is 09/24/2004. European format is dd/mm/yyyy, for example,
September 24, 2004 is 24/09/2004.
Time Zone—Click the field and choose a city within your time zone from the drop-down list. The
list displays the 80 World Time Zones from –11 through 0 (GMT) to +14. Continental United States
time zones are GMT-05:00 (Eastern), GMT-06:00 (Central), GMT-07:00 (Mountain), and
GMT-08:00 (Pacific).
Use Daylight Savings Time—Check this check box if the time zone that you chose uses Daylight
Savings Time.
4-6.
This procedure provisions extreme high extreme low, and low input battery
power thresholds within a –48 volts direct current (VDC) environment.
When the thresholds are crossed, the TCC2/TCC2P generates warning
alarms in CTC.
None
NTP-D24 Verify Card Installation, page 4-2
Required
Onsite or remote
Provisioning or higher
"DLP-D60 Log into CTC" task on page 17-49
Chapter 4
3
through
"NTP-D279 Set Power Monitor Thresholds"
for the node you will set up. If you are
Turn Up a Node
5
to enter the
78-17194-01
Advertisement
Chapters
Table of Contents
