Cisco ONS 15454 SDH Procedure Manual page 29

Procedures
NTP-D48 Subtend an MS-SPRing from an MS-SPRing
5-41
NTP-D172 Create a Logical Network Map
5-43
Create Circuits and Low-Order Tunnels
6-1
NTP-D127 Verify Network Turn-Up
6-5
NTP-D334 Create an Automatically Routed Low-Order VC11 Circuit
6-7
NTP-D335 Create a Manually Routed Low-Order VC11 Circuit
6-12
NTP-D336 Create a Unidirectional Low-Order VC11 Circuit with Multiple Drops
6-15
NTP-D81 Create an Automatically Routed Low-Order VC12 Circuit
6-19
NTP-D82 Create a Manually Routed Low-Order VC12 Circuit
6-24
NTP-D83 Create a Unidirectional Low-Order VC12 Circuit with Multiple Drops
6-27
NTP-D54 Create an Automatically Routed Low-Order VC3 Circuit
6-31
NTP-D55 Create a Manually Routed Low-Order VC3 Circuit
6-35
NTP-D56 Create a Unidirectional Low-Order VC3 Circuit with Multiple Drops
6-38
NTP-D133 Create an Automatically Routed Low-Order Tunnel
6-42
NTP-D134 Create a Manually Routed Low-Order Tunnel
6-45
NTP-D216 Create a Low-Order Path Tunnel for Port Grouping
6-47
NTP-D187 Create a Low-Order Aggregation Point
6-50
NTP-D135 Test Low-Order Circuits
6-53
NTP-D323 Create an Automatically Routed High-Order Circuit
6-55
NTP-D324 Create a Manually Routed High-Order Circuit
6-60
NTP-D190 Create a Unidirectional High-Order Circuit with Multiple Drops
6-63
NTP-D62 Test High-Order Circuits
6-66
NTP-D139 Create a Half Circuit on an MS-SPRing or 1+1 Node
6-68
NTP-D140 Create a Half Circuit on an SNCP Ring Node
6-70
NTP-D191 Create an E-Series EtherSwitch Circuit (Multicard or Single-Card Mode)
6-72
NTP-D192 Create a Circuit for an E-Series Card in Port-Mapped Mode
6-75
NTP-D142 Create an E-Series Shared Packet Ring Ethernet Circuit
6-77
NTP-D143 Create an E-Series Hub-and-Spoke Ethernet Configuration
6-80
NTP-D144 Create an E-Series Single-Card EtherSwitch Manual Cross-Connect
6-82
NTP-D145 Create an E-Series Multicard EtherSwitch Manual Cross-Connect
6-85
NTP-D146 Test E-Series Circuits
6-89
NTP-D148 Create a Manual Cross-Connect for a G-Series or E-Series Card in Port-Mapped Mode
6-90
NTP-D241 Provision G-Series Ports for Transponder Mode
6-92
NTP-D149 Test G-Series Circuits
6-95
NTP-D194 Create Overhead Circuits
6-96
Cisco ONS 15454 SDH Procedure Guide, R7.0
v
78-17194-01