Table of Contents
Advertisement
DLP- D260 Set Auto-Refresh Interval for Displayed PM Counts
•
•
•
Click Refresh. The PM counts refresh with values based on the selected time interval.
Step 5
Return to your originating procedure (NTP).
Step 6
DLP-D260 Set Auto-Refresh Interval for Displayed PM Counts
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the card where you want to view PM counts. The card view appears.
Step 1
Click the Performance tab.
Step 2
Click the Auto-refresh drop-down list and choose one of the following options:
Step 3
•
•
•
•
•
•
Click Refresh. The PM counts for the newly selected auto-refresh time interval appear.
Step 4
Depending on the selected auto-refresh interval, the PM counts are automatically updated when each
refresh interval completes. If the auto-refresh interval is set to None, the PM counts that appear are not
updated unless you click Refresh.
Return to your originating procedure (NTP).
Step 5
Cisco ONS 15454 SDH Procedure Guide, R7.0
19-64
15 min: This option displays the specified PM counts in fifteen-minute time intervals.
1 hour: This option displays the specified PM counts in one-hour time intervals.
1 day: This option displays the specified PM counts in one-day (24 hours) time intervals.
None: This option disables the auto-refresh feature.
15 Seconds: This option sets the window auto-refresh at 15-second time intervals.
30 Seconds: This option sets the window auto-refresh at 30-second time intervals.
1 Minute: This option sets the window auto-refresh at 1-minute time intervals.
3 Minutes: This option sets the window auto-refresh at 3-minute time intervals.
5 Minutes: This option sets the window auto-refresh at 5-minute time intervals.
This task changes the auto-refresh intervals for updating the displayed
PM counts in a window.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Retrieve or higher
Chapter 19
DLPs D200 to D299
78-17194-01
Advertisement
Chapters
Table of Contents
