Dlp- D432 View Port Status On The Lcd - Cisco ONS 15454 SDH Procedure Manual

Chapter 21 DLPs D400 to D499
Suppressed alarms will reappear in the Alarms window. (They might have previously been cleared from
the window using the Synchronize button.) The AS-CMD alarm with the slot object (for example,
SLOT-16) will be cleared in all views.
To discontinue alarm suppression for ports, click the following tabs:
Step 3
•
•
Step 4 Uncheck the Suppress Alarms check box for the port(s) you no longer want to suppress.
Step 5 Click Apply.
Suppressed alarms will reappear in the Alarms window. (They might have previously been cleared from
the window using the Synchronize button.) The AS-CMD alarm with the port object (for example,
FAC-16-1) will be cleared in all views.
Return to your originating procedure (NTP).
Step 6
DLP-D432 View Port Status on the LCD
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Press the Slot button on the LCD panel until the desired slot appears on the LCD.
Step 1
Press the Port button until the desired port appears on the LCD.
Step 2
Press the Status button. After approximately 10 seconds, the LCD will indicate if the port is in working
Step 3
or protect mode and is active or standby.
Figure 21-8
78-17194-01
If the card is an FC_MR-4, E-Series Ethernet, G-Series Ethernet, STM-N, or electrical card
(DS3i-N-12, E-1, E1-42, or E-3), click the Provisioning > Alarm Profiles > Alarm Behavior tabs.
If the card is an ML-Series Ethernet card, click the Provisioning > Ether Alarming >
Alarm Behavior tabs or the Provisioning > POS Alarming > Alarm Behavior tabs, depending on
whether you want to apply the profile to the front physical ports ("Ether alarming") or packet over
SDH ("POS alarming"). For more information about ML-Series card ports and service, see the
Ethernet Card Software Feature and Configuration Guide for the Cisco ONS 15454,
Cisco ONS 15454 SDH, and Cisco ONS 15327.
This task allows you to view STM-N port status without using CTC. The
LCD shows the working/protection provisioning status and the
active/standby line status for ports in 1+1 and multiplex section-shared
protection ring (MS-SPRing) configurations. For unprotected and
subnetwork connection protection (SNCP) ports, the LCD always shows
"Working/Active."
None
NTP-D16 Install STM-N Cards and Connectors, page 2-7
As needed
Onsite
None
shows an example of port status on the LCD panel.

DLP- D432 View Port Status on the LCD

Cisco ONS 15454 SDH Procedure Guide, R7.0
21-17