Selecting The Ip Address Option - Cisco ONS 15454 SDH Procedure Manual

DLP- D64 Set the IP Address, Default Router, and Network Mask Using the LCD
The LCD reverts to normal display mode after 5 seconds of button inactivity.
Note
On the ONS 15454 SDH front panel, repeatedly press the Slot button until Node appears on the LCD.
Step 1
Repeatedly press the Port button until the following displays:
Step 2
To change the node IP address, Status=IpAddress
•
To change the node network mask, Status=Net Mask
•
To change the default router IP address, Status=Default Rtr
•
Figure 17-12
FAN FAIL
Press the Status button to display the node IP address
Step 3
the default router IP address.
Figure 17-13
FAN FAIL
Push the Slot button to move to the IP address or subnet mask digit that you need to change. The selected
Step 4
digit flashes.
The Slot, Status, and Port button positions correspond to the command position on the LCD. For
Tip
example, in
invoke the Done command.
Press the Port button to cycle the IP address or subnet mask to the correct digit.
Step 5
When the change is complete, press the Status button to return to the Node menu.
Step 6
Repeatedly press the Port button until the Save Configuration option appears
Step 7
Cisco ONS 15454 SDH Procedure Guide, R7.0
17-54

Selecting the IP Address Option

Slot Status Port
CRIT MAJ MIN
Changing the IP Address
Slot Status
CRIT MAJ
Figure 17-13, you press the Slot button to invoke the Next command and the Port button to
(Figure
Slot-0
Status=IpAddress
(Figure
Port
172.020.214.107
<Next Done
MIN
Chapter 17
17-12)
17-13), the node subnet mask length, or
Mod>
(Figure 17-14).
DLPs D1 to D99
78-17194-01