Figure 15-2 Restoring The Tcc2/Tcc2P Database - Cisco ONS 15454 SDH Procedure Manual

Chapter 15 Maintain the Node
Ensure that no ring or span (four-fiber only) switch events are present; for example, RING-SW-EAST,
Step 2
RING-SW-WEST, SPAN-SW-EAST, or SPAN-SW-WEST. In network view, click the Conditions tab
and click Retrieve to view a list of conditions.
If switch events need to be cleared, in node view click the Maintenance > MS-SPRing tabs and view
Step 3
the West Switch and East Switch columns.
If a switch event is present, choose CLEAR from the drop-down list and click Apply.
Step 4
Note
When a switch event is cleared, NO COMMAND appears in the column to indicate that the switch event
is no longer in effect.
In node view, click the Maintenance > Database tabs
Step 5
Figure 15-2
Click Restore.
Step 6
Locate the database file stored on the workstation hard drive or on network storage.
Step 7
Note
Click the database file to highlight it.
Step 8
Click Open. The DB Restore dialog box appears.
Step 9
78-17194-01
A switch, if present, might have been caused by a standing Wait to Restore (WTR) condition.
Restoring the TCC2/TCC2P Database
To clear all existing provisioning, locate and upload the database found on the latest
ONS 15454 SDH software CD.
NTP- D109 Restore the Database
(Figure 15-2).
Cisco ONS 15454 SDH Procedure Guide, R7.0
15-7