Cisco ONS 15454 SDH Procedure Manual page 693

Chapter 20 DLPs D300 to D399
DLP-D318 Provision a Low-Order VC3 Circuit Source and Destination
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
After you have selected the circuit properties in the Circuit Source dialog box according to the specific
Note
circuit creation procedure, you are ready to provision the circuit source.
From the Node drop-down list, choose the node where the source will originate.
Step 1
From the Slot drop-down list, choose the slot containing the E3-12 or DS3i-N-12 card where the circuit
Step 2
will originate. You can also choose an STM-N card to map the VC3 to a VC4 for optical transport.
Figure 20-2
Figure 20-2
Step 3 Choose the port from the Port drop-down list.
Choose the VC4 from the VC4 drop-down list.
Step 4
Choose the VC3 from the VC3 drop-down list.
Step 5
78-17194-01
This task provisions a circuit source and destination for a low-order VC3
circuit.
None
DLP-D60 Log into CTC, page 17-49
NTP-D54 Create an Automatically Routed Low-Order VC3 Circuit, page
6-31, or
NTP-D55 Create a Manually Routed Low-Order VC3 Circuit, page
or
NTP-D56 Create a Unidirectional Low-Order VC3 Circuit with Multiple
Drops, page 6-38
You must have the Source page of the Circuit Creation wizard open.
As needed
Onsite or remote
Provisioning or higher
shows an example of a circuit source for an E3-12 card.
Defining the Circuit Source on an E3-12 Card
DLP- D318 Provision a Low-Order VC3 Circuit Source and Destination
Cisco ONS 15454 SDH Procedure Guide, R7.0
6-35,
20-9