Cisco ONS 15454 SDH Procedure Manual page 343

Convert Network Configurations
This chapter explains how to convert from one SDH topology to another in a Cisco ONS 15454 SDH
network. For initial network turn-up, see
Before You Begin
Before performing any of the following procedures, investigate all alarms and clear any trouble
conditions. Refer to the Cisco ONS 15454 SDH Troubleshooting Guide as necessary.
This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
78-17194-01
NTP-D338 Convert a Point-to-Point to a Linear ADM Automatically, page
needed.
NTP-D154 Convert a Point-to-Point to a Linear ADM Manually, page
if the in-service topology upgrade wizard is not available or you need to back out of the wizard.
NTP-D318 Convert an Unprotected Point-to-Point or Linear ADM to a Two-Fiber MS-SPRing
Automatically, page 13-6—Complete as needed.
NTP-D155 Convert a Point-to-Point or a Linear ADM to a Two-Fiber MS-SPRing Manually, page
13-8—Complete as needed if the in-service topology upgrade wizard is not available or you need to
back out of the wizard.
NTP-D351 Convert a Point-to-Point or Linear ADM to an SNCP Automatically, page
13-10—Complete as needed.
NTP-D156 Convert a Point-to-Point or Linear ADM to an SNCP Manually, page
as needed if the in-service topology upgrade wizard is not available or you need to back out of the
wizard.
NTP-D320 Convert an SNCP to a Two-Fiber MS-SPRing Automatically, page
needed.
NTP-D210 Convert an SNCP to a Two-Fiber MS-SPRing Manually, page
needed if the in-service topology upgrade wizard is not available or you need to back out of the
wizard.
NTP-D211 Convert a Two-Fiber MS-SPRing to a Four-Fiber MS-SPRing Automatically, page
13-16—Complete as needed.
NTP-D159 Modify an MS-SPRing, page
C H A P T E R
Chapter 5, "Turn Up a Network."
13-18—Complete as needed.
Cisco ONS 15454 SDH Procedure Guide, R7.0
13
13-2—Complete as
13-4—Complete as needed
13-11—Complete
13-12—Complete as
13-14—Complete as
13-1