Ntp- D148 Create A Manual Cross-Connect For A G-Series Or E-Series Card In Port-Mapped Mode - Cisco ONS 15454 SDH Procedure Manual

NTP- D148 Create a Manual Cross-Connect for a G-Series or E-Series Card in Port-Mapped Mode

Note
At the source node, connect an Ethernet test set to the source port and configure the test set to send and
Step 8
receive the appropriate Ethernet traffic.
Transmit Ethernet frames between both test sets. If you cannot transmit and receive Ethernet traffic
Step 9
between the nodes, repeat Steps
set correctly.
Perform protection switch testing appropriate to the topology:
Step 10
•
•
Configure your test set according to local site practice. For information about configuring your test set,
see your test set user guide.
Step 11 After the Ethernet test is complete, print the results or save them to a disk for future reference. For
information about printing or saving test results, see your test set user guide.
Stop. You have completed this procedure.
NTP-D148 Create a Manual Cross-Connect for a G-Series or
E-Series Card in Port-Mapped Mode
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In this procedure, cross-connect refers to a circuit connection created within the same node between the
Note
Ethernet card and an STM-N card connected to third-party equipment. You create cross-connects at the
source and destination nodes so an Ethernet circuit can be routed from source to destination across
third-party equipment.
Complete the
Step 1
the cross-connect. If you are already logged in, continue with
Step 2 If you are provisioning an E-Series card, verify that the Ethernet card that will carry the circuit is
provisioned for port-mapped mode. See the
on page
If you are provisioning a G-Series card, complete the
Step 3
task on page
Cisco ONS 15454 SDH Procedure Guide, R7.0
6-90
At this point, you are not able to send and receive Ethernet traffic.
For SNCP rings, see the "DLP-D94 SNCP Protection Switching Test" task on page 17-91
For MS-SPRings see the "DLP-D91 MS-SPRing Switch Test" task on page
This procedure manually creates a cross-connect between a G-Series
Ethernet card or an E-Series Ethernet card in Port-mapped mode and an
STM-N card connected to non-ONS equipment.
A G-Series or E-Series card must be installed at the circuit source node.
NTP-D127 Verify Network Turn-Up, page 6-5
As needed
Onsite or remote
Provisioning or higher
"DLP-D60 Log into CTC" task on page 17-49
19-50.
19-21.
2 through 8 to make sure that you configured the Ethernet ports and test
"DLP-D246 Provision E-Series Ethernet Card Mode" task
"DLP-D222 Provision G-Series Ethernet Ports"
Chapter 6 Create Circuits and Low-Order Tunnels
17-84.
at an ONS 15454 SDH where you will create
Step 2.
78-17194-01