Cisco ONS 15454 SDH Procedure Manual page 522

DLP- D108 Change Line Settings for STM-N Cards
Table 18-1 STM-N Card Line Settings (continued)
Parameter Description
Port Rate (Display only) (MRC-12 and STM64-XFP cards
only) Displays the port rate set for the PPM.
SF BER Sets the signal fail bit error rate.
SD BER Sets the signal degrade bit error rate.
Provides (Display only) If checked, the card is
Synch provisioned as a network element (NE) timing
reference.
Send Do Not When checked, sends a do not use (DUS)
Use message on the S1 byte.
Synch Enables synchronization status messages
Message In (SSMs) (S1 byte), which allow the node to
choose the best timing source.
Send <FF> When checked, sends a special DUS (0xff)
DoNotUse message on the S1 byte.
Admin SSM In Overrides the synchronization traceability
unknown (STU) value (default setting). You
cannot select Admin SSM In if Sync Message In
is enabled on the STM-N card.
MS-SPRing Allows you to change the multiplex
Ext. Byte section-shared protection ring (MS-SPRing)
extension byte.
PJVC4Mon # Sets the VC4 that will be used for pointer
justification. If set to 0, no VC4 is monitored.
Only one VC4 can be monitored on each STM-N
port.
Cisco ONS 15454 SDH Procedure Guide, R7.0
18-10
Options
STM-1
•
STM-4
•
STM-16
•
STM-64 (STM64-XFP only)
•
1E-3
•
• 1E-4
• 1E-5
1E-5
•
1E-6
•
1E-7
•
1E-8
•
1E-9
•
Yes
•
No
•
Yes
•
No
•
• Yes
• No
• Yes
• No
G811
•
G812T
•
G812L
•
SETS
•
DUS
•
K3
•
Z2
•
E2
•
• F1
0 - 1 (STM-1, per port)
•
0 - 4 (STM-4, per port)
•
0 - 16 (STM-16)
•
0 - 64 (STM-64)
•
Chapter 18 DLPs D100 to D199
78-17194-01