Dlp- D349 View Ml-Series Pos Ports Pm Parameters - Cisco ONS 15454 SDH Procedure Manual

Chapter 20 DLPs D300 to D399
View the PM parameter names that appear in the Param column. The PM parameter values appear in the
Step 4
Port # columns. For PM parameter definitions, refer to the "Performance Monitoring" chapter in the
Cisco ONS 15454 SDH Reference Manual.
Note
Return to your originating procedure (NTP).
Step 5
DLP-D349 View ML-Series POS Ports PM Parameters
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
For ML-Series card provisioning, refer to the Ethernet Card Software Feature and Configuration Guide
Note
for the Cisco ONS 15454, Cisco ONS 15454 SDH, and Cisco ONS 15327.
In node view, double-click the ML-Series Ethernet card where you want to view PM counts. The card
Step 1
view appears.
Step 2 Click the Performance > POS Ports tabs
78-17194-01
To refresh, reset, or clear PM counts, see the
on page 8-2.
This task enables you to view packet-over-SDH (POS) port PM counts
at selected time intervals on an ML-Series Ethernet card and port to
detect possible performance problems.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Retrieve or higher

DLP- D349 View ML-Series POS Ports PM Parameters

"NTP-D257 Change the PM Display" procedure
(Figure 20-12).
Cisco ONS 15454 SDH Procedure Guide, R7.0
20-57